#FORD IDS LIN MODULE SOFTWARE#
Run IDSQuickLoader again, you will see current software and firmware version
#FORD IDS LIN MODULE UPDATE#
Start Ford IDS QuickLoader on desktop, it will ask for Firmware Update Make sure the communication indicator of svci flashes Note: Must update firmware to 001.031 version or above version.Ĭonnect svci j2534 interface with vehicle Here is a demo guide on SVCI J2534 J1850 PWM module programming:
#FORD IDS LIN MODULE DOWNLOAD#
Run icon SVCI-J2534-Ford-Quickloader (internet connection should be ON)Īll of those installer packages you can find in download section from flyobd website (check download link above.) So it will reprogram J1850 modules without issue.ĥ. for the older ones you need the vcm2.įLY Technician has solved the J1850 PWM protocol module programming bugs.
Turn the ignition lock cylinder to the RUN position or press the START/STOP button. Place the second key in the ignition lock cylinder or the backup starting location. Turn the ignition lock cylinder to the OFF position or press the START/STOP button and remove the first key. Turn the ignition lock cylinder to the RUN position or press the START/STOP button and wait approximately 6 seconds. Refer to: Passive Anti-Theft System (PATS) - System Operation and Component Description (419-01C Passive Anti-Theft System (PATS) - Vehicles With: Keyless Vehicle System, Description and Operation). Place the first key in the ignition lock cylinder or the backup starting location. NOTE: A diagnostic scan tool should not be used to program keys for this specific step. NOTE: Carry out the remaining steps only if installing a new BCM. Refer to: Factory Mode Deactivation (419-10 Multifunction Electronic Modules, General Procedures). Refer to: Transport Mode Deactivation (419-10 Multifunction Electronic Modules, General Procedures). Follow the steps to deactivate transport or factory mode.ĭeactivate transport or factory mode in the BCM. NOTE: Some replacement BCM may be in transport or factory mode. To install, reverse the removal procedure.
NOTE: If installing a new BCM, verify at least 2 of the vehicle keys are available prior to carrying out this procedure.
If necessary, use the previous diagnostic scan tool session or start a diagnostic scan tool session using the PCM part number or tear tag number located on the PCM. The BCM still communicates with the diagnostic scan tool with the ignition off. NOTE: If installing a new BCM, the ignition cannot be turned on until 2 keys are programmed to the vehicle.